Classified Ad Posted 3 hours ago in Used Cooling and Heating Equipment by David Holm (1847 views)
600 gallon horizontal HLT that is a converted dairy tank. Has two 3 inch tri-clamp ports on back of unit and two 1.5 tri-clamp ports on the front of the unit (one is sloped for liquid egress.). Comes with 2 tri-clamp cap reducers. One 3 inch to 2 inch and one 3 inch to 1.5 inch. takes 2inch tri-clamp 15,000KW element. $1500 without element $2100 with element.
Classified Ad Posted 5 hours ago in Used Cooling and Heating Equipment by Lee Katrincic (177 views)
11 TankNet PL-1 controllers, valves actuators (only found 10) and temp probes. Also, includes TankNet Smartserver. Bought them at a brewery auction for my canned cocktail setup but never used them. They were functioning when I removed them from the brewery a few years ago. No idea of their value, thus the 'best offer' designation. See pics and let me know if you have any questions. If you aren't familiar with these you may have to contact the manufacturer for install. Buyer to arrange shipping. Thanks!
Classified Ad Posted 8 hours ago in Used Cooling and Heating Equipment by Mike Geller (298 views)
Recently upgraded our chiller to handle growing capacity. Up for sale is our 7.5 ton Econochill indoor chiller model CCU-075A-23. The reservoir holds approximately 50 gallons, but glycol is not included in the sale. Refrigerant is R-404A. It's an indoor rated unit. Compressor controls recently replaced and unit was in good working order upon decommissioning 5 weeks ago. We used the chiller in conjunction with 2 x 20bbl FVs, 20bbl BBT, 15bbl CLT, 7 x 10bbls Unitanks and 4-1bbl FVs. Regularly canned and had beer down at 31 degrees and had no issues lagering at 32 for extended periods. Prefer local pickup. We have a forklift and can load into a truck. Unit is the size of a standard pallet and weighs around 1,000lbs. We have the chiller fully decommissioned and it is available immediately. Email for pictures.
Classified Ad Posted 3 days ago in Used Cooling and Heating Equipment by BeachFly (715 views)
Accu-therm plate heat exchanger 68 plate Mueller heat exchanger. On casters for easy moving $3000 Buyer is responsible for shipping
Classified Ad Posted 5 days ago in Used Cooling and Heating Equipment by whalers (1060 views)
Upgrading chillers, we are the original owners, bought this new in 2017. Has been a great chiller, pulled from service in great shape. Specs are: Manufacturer: Temptek Model: CFD-10A (10 ton rating) Serial: 156084 Year: 2017 Manufactured: USA Compressor: 10 hp Process pump: 2 hp Ships from RI, we'll build a solid pallet and strap / protect the 4 edges. Feel free to message with any questions. Manufacturer's website for this chiller: https://www.ameritempgroup.com/store/p1555/TempTek_CFD-10A_10_Ton_Portable_Air-Cooled_Water_Chiller.html
Classified Ad Posted 1 week ago in Used Cooling and Heating Equipment by AgerTank (1093 views)
Now Available - Item is a used Temptek 20 HP glycol/water chiller. This unit is a model CF-20AB and was manufactured new in mid 2017. The machine is set up to opperate at 460/3/60 electrical specifications. The machine is a 20 ton unit that consists of the following: 20 Hp Compressor - Hermetic scroll type 410A refrigerant 3hp Stainless steel centrifugal process pump 2IN process connection Air cooled condenser with blower 65 gallon holding tank Dimensions - 58"x70'x 96in tall Shipping weight - 2600# This machine was removed from service recently and replaced with a larger unit. It ready to ship. Selling Price - $12,500 Please call/text/email for delivered price.
Classified Ad Posted 1 week ago in Used Cooling and Heating Equipment by Dustin Williams (1011 views)
Cool bot walk in freezer controller for use with a window unit A/C (not included). Works great and always kept our cold room at 34 degrees F. Shipping in the US included in the price.
Classified Ad Posted 1 week ago in Used Cooling and Heating Equipment by mickshouse1 (7362 views)
Micro-matic 3/4 HP, 5100 BTU glycol pack immediately available, purchased new in 2014, dual pumps, can be used for trunk beer lines (up to 350') or direct tank control, replaced digital controls 3 years ago, replaced 1 pump 1.5 years ago. Requires 230V, single phase power. Coolant gas is R134A, 11.5 Gallon glycol bath. Dimensions are roughly 29'' x 18"x 30" high. Weighs around 170 pounds. We will take the ad down if its' sold and will not answer availability questions. You pay shipping and crating from Reno, NV 89511
Classified Ad Posted 2 weeks ago in Used Cooling and Heating Equipment by Ryan Porter (1382 views)
For sale is one used Chillstar 3hp glycol chiller. This unit was in production just a few weeks ago when I bought it and had it shipped to my brewery. Unfortunately I overlooked this is a 3 phase wired chiller and we only have single phase available. I have already purchased the replacement and this one is ready to go. It's in really nice condition, was well cared for and very clean. Control panel is immaculate, normal wear from being outside but as I said, this unit is solid and was adequately cooling 64bbl of capacity in New York. Asking $7,000 OBO.
Classified Ad Posted 2 weeks ago in Used Cooling and Heating Equipment by Andy Weiner (3095 views)
Dual 1/4hp motors. We tested it’s functionality and it works well and should chill lines up to 200’ long, comparable new units seem to advertise lengths up to 250’ and go for about $2,400. With the unit comes with ~30 gallons of glycol and some fittings.
Classified Ad Posted 2 weeks ago in Used Cooling and Heating Equipment by Rick Callow (12464 views)
Insulated SST Cold Water Storage and Transfer Skid, Square SST Storage Tank with Point Level Controller, Dual Transfer Pumps, Insulated SST Suction and Discharge Piping all mounted to a SST angle iron frame with adjustable feet
Classified Ad Posted 2 weeks ago in Used Cooling and Heating Equipment by Rick Callow (12653 views)
371 Gallon single wall bulk ambient water tank, with Hitachi Neuro Jr Water Ace chiller package with single pass cooling, on-board in-line sanitary strainer, all stainless steel sch. pipe manifolds included with associated butterfly valves. Tank, Chiller, Strainer and related piping mounted to a SST angle iron frame with adjustable feet. Note: tank head space is badly rusted and will need mechanical polishing and a strong acid wash to get it anywhere near good. Might be best to replace the top head. Other components are in really good shape. Caution: the unit requires 50 Hrtz power.
Classified Ad Posted 2 weeks ago in Used Cooling and Heating Equipment by Rick Callow (12155 views)
Insulated SST Hot Water Storage and Transfer Skid, Square SST Bulk Storage Tank. Dual Transfer Pumps, Point Level Controller, Insulated SST Suction and Transfer Piping, all mounted to a SST angle iron frame with adjustable feet. Note: transfer pumps exhibit a lot of external rust
Classified Ad Posted 2 weeks ago in Used Cooling and Heating Equipment by Josh Ridlon (5342 views)
We purchased this walk in New, and used it from January to October of last year. Like new condition. Condenser was kept indoors. The evaporator has an Artic Fox temperature control that can be monitored and controlled from your phone. The dimensions of the cooler are 9' 8" square by 8' 6" tall. Local pickup only
Classified Ad Posted 2 weeks ago in Used Cooling and Heating Equipment by Tim Ginter (1396 views)
Large ACCUREX commercial vent-fan with 16in round inlet, 16x12 rectangular outlet. 1hp motor, 115/208-230v single phase. For use with commercial kitchen vent-hoods, industrial steam or dust extraction, and has grease removal capabilities. Very little use, purchased for a brewery and was only used 5 or 6 times. Been in storage for a few years. Local pickup is preferred but we can figure out shipping details if needed. https://www.accurex.com/products/exhaust-fans/utility-set/xuef
Classified Ad Posted 3 weeks ago in Used Cooling and Heating Equipment by Jason Elliott (1629 views)
3/4hp glycol chiller for sale. $2,600 OBO. We bought this new and used it for 20 months to chill two 3.5bbl unitanks and two 7bbl unitanks. We just upgraded so this one is ready for a new home. If interested please contact Jason at jason@myriadbrewing.com
Classified Ad Posted 3 weeks ago in Used Cooling and Heating Equipment by William Neenan (1524 views)
This is our used Chiller being sold as for our larger Chiller is now online. Very good condition and no issues. Also have some piping and electrical that was removed with the Chiller upgrade.
Classified Ad Posted 3 weeks ago in Used Cooling and Heating Equipment by Jacqueline Rusher (1738 views)
This 13.5 HP 2 pump glycol chiller is detached and ready for pickup. It is a 3 Phase 208/240. One pump is 1.5 hp the other is a 5 hp. Please contact me with any questions. we can help arrange shipping but it is the sellers responsibility to have it shipped. Financing available.
Classified Ad Posted 3 weeks ago in Used Cooling and Heating Equipment by Rick Callow (15518 views)
Fully functional electric vaporizer, 1,500 Pounds per hour vaporized CO2 @ 70°F, 460 volt 3-phase. Unit was in a "back-up" service for the past several years and works great. All plate circuits were recently test and passed no problem. 1" inlet /outlet. Includes inlet shut-off solenoid.
Classified Ad Posted 3 weeks ago in Used Cooling and Heating Equipment by Rick Callow (8101 views)
1 ea. Barnstead CO2 Series Incubator, Model Thermolyne, Type 15330, 120 VAC, Comes with three (3) stainless steel shelves and the original operations manual. Unit turns right on and develops heat based upon dial settings, but needs the CO2 inlet fitting to be straightened out it has been bent.