Suction and discharge hose (Standard brewers hose) – may be used for both CIP and product transfer. Hose meets 3A, USDA and FDA requirements. Rated for working pressures up to 150 psi. Handles temperature ranges from -40 to 225F. Comes in your choice of 3 colors – Red, Gray or Blue with white stripe. Ends are permanent crimp, sanitary tri-clamp connections. Contact firstname.lastname@example.org for pricing or more information. Please include the hose size and length needed in your request. Thanks!
The washdown station delivers a high temp wash down using a proprietary mixing valves that combines steam and water for a constant stream at your set temperature. The safety shutoff feature essentially eliminates the risk of 'a hose full of steam', thereby decreasing hazards in your brewery. The mixing valve is designed to reduce flow should the output temp exceed the factory set point of 185F and will completely shut down 15F above that. Flow will only restore once temps fall below the shutoff temperature. Operation of the Wash Down Station Product Specifications
WCB Sanitary Centrifugal pump, Model C114 with a 1.5 HP motor (3500 rpm), mounted on a 2-wheel cart with variable frequency drive. Deliverables Sanitary centrifugal pump by Waukesha Cherry-Burrell Model C-114 Connections – sanitary triclamp Impeller diameter – 4” Type D single mechanical seal (carbon vs SS back plate) Buna elastomers Finish – 32Ra Baldor 1.5 HP, 3500 RPM, washdown enclosure, 56C frame Cart Made of round tubular 304 stainless steel, polished finish 2 solid rubber wheels with front support post. Handle for operator use (broke back). Variable Frequency Drive – AC-Tech, NEMA-4X enclosure, 230 Volts AC. Pump and drive mounted on cart and pre-wired. 20’ of power cable (no plug) – plug added at no cost once power requirements are known
Transfer and suction hose built with wide/smooth corrugations on the outside to reduce friction and to make it easier to move around the floor. Suitable for CIP/COP and product transfer. Meets 3A, USDA and FDA requirements. Handles a working pressure up to 150 psi. Handles temperature ranges from -40 to 250F. Ends are permanent crimp, tri-clamp connections. Contact email@example.com for pricing or more information.