The washdown station delivers a high temp wash down using a proprietary mixing valves that combines steam and water for a constant stream at your set temperature. The safety shutoff feature essentially eliminates the risk of 'a hose full of steam', thereby decreasing hazards in your brewery. The mixing valve is designed to reduce flow should the output temp exceed the factory set point of 185F and will completely shut down 15F above that. Flow will only restore once temps fall below the shutoff temperature. Operation of the Wash Down Station Product Specifications
Description of Product 3M Liquicel membrane contactor for infusing gasses into or removing gasses from liquids, with a 0.75 HP motor (3450 rpm) on a 4 stage pump mounted on a 2-wheel cart with variable frequency drive. Deliverables Nitro/Carbonation Infusion system 3M Liquicel membrane contactor, item G572, flow rate 10-15 gpm Connections –sanitary clamp Baldor motor, 0.75 HP, 208-230/460 volt, 3450 rpm, wash down enclosure Goulds pump, 4 stage centrifugal, 50 psi discharge pressure at 15 gpm Gas regulating system including inlet/outlet valves, air flow meter and gas pressure regulator Pressure gauges to monitor inlet and outlet liquid pressure Includes sampling valve and drain Cart Made of round tubular 304 stainless steel, polished finish 2 solid rubber wheels with front support posts. Handle for operator use (broke back). Variable Frequency Drive – ABB, NEMA-4X enclosure, TBD Volts AC. Pump and drive mounted on cart and pre-wired. 20’ of power cable...
Transfer and suction hose built with wide/smooth corrugations on the outside to reduce friction and to make it easier to move around the floor. Suitable for CIP/COP and product transfer. Meets 3A, USDA and FDA requirements. Handles a working pressure up to 150 psi. Handles temperature ranges from -40 to 250F. Ends are permanent crimp, tri-clamp connections. Contact firstname.lastname@example.org for pricing or more information.
We have 6 x 16" EK lenticular filters (0.45 micron) in obsolete inventory. We would like to sell them by the end of the year. Filters are brand new, still in original box. Will accept best offer for them. Contact by email.
WCB Sanitary Centrifugal pump, Model C114 with a 1.5 HP motor (3500 rpm), mounted on a 2-wheel cart with variable frequency drive. Deliverables Sanitary centrifugal pump by Waukesha Cherry-Burrell Model C-114 Connections – sanitary triclamp Impeller diameter – 4” Type D single mechanical seal (carbon vs SS back plate) Buna elastomers Finish – 32Ra Baldor 1.5 HP, 3500 RPM, washdown enclosure, 56C frame Cart Made of round tubular 304 stainless steel, polished finish 2 solid rubber wheels with front support post. Handle for operator use (broke back). Variable Frequency Drive – AC-Tech, NEMA-4X enclosure, 230 Volts AC. Pump and drive mounted on cart and pre-wired. 20’ of power cable (no plug) – plug added at no cost once power requirements are known
Suction and discharge hose (Standard brewers hose) – may be used for both CIP and product transfer. Hose meets 3A, USDA and FDA requirements. Rated for working pressures up to 150 psi. Handles temperature ranges from -40 to 225F. Comes in your choice of 3 colors – Red, Gray or Blue with white stripe. Ends are permanent crimp, sanitary tri-clamp connections. Contact email@example.com for pricing or more information. Please include the hose size and length needed in your request. Thanks!