RAD Mil + Auger + Control Panel ( $10,500 )
Never used RAD MILL and AUGER with custom CONTROL PANEL.
We bought this set up at the end of 2018. Unfortunately, due to unforeseen circumstances, we were not able to install and use the equipment.
We purchased the mill & auger from ABM Equipment – Vancouver, WA.
The custom control panel was built by Prairie Electric out of Vancouver, WA.
RAD MODEL 200 ROLLER MILL
- Capacity of 40 lbs/min
- 2 – 6½” Dia. x 7½ Width roller with 10½ splines per inch
- 3 HP TEFC Motor, 230-460V/60htz/3ph, 184T Frame
- Independent adjustment of gap and pressure.
- 2 v-belts main drive with chain slave drive
- OSHA belt and chain guards
- Inlet feed hopper with grate, magnet, and flow adjustment slide gate
- Discharge hopper to mate Choretime ® auger (inclined 45º)
- Adjustable support stand
- Infeed hopper cover w/ piano hinge, 4” inlet, 2” dust sock
- Allow for addition of specialty malts while controlling dust
FLEX AUGER FROM MILL TO GRIST CASE
- Model 90 chore time auger
- Average convey rate 100 lbs. / min
- 30’ x 3” Flex Auger with up to 2 – 45º bends, PVC convey tube
- 3/4 HP 110-230/3/60 TEFC Motor
- Manual reset plug sensor (not to be used for level control or cycling equipment on and off)
- Discharge: 304 SS transition to 4” dia. stub with 5’ food grade grounded flex
- Infeed: Lower boot with bearing assembly and access door